Tensorgrip L17 Laminate Contact Adhesive Aerosol

Product Information

Tensorgrip® L17 is a high performance contact adhesive with a unique resin formula which creates a tough and resilient bond line between decorative surface materials and all common wood substrates. Suitable for bonding HPL, GRP and aluminium to a wide variety of substrates including MDF, chipboard, plywood and many other timber sheet materials and is designed for permanent bonding where immediate bond strength and high heat resistance are required.

• Class 1 Fire rated
• Fast, High Tack
• Excellent high coverage
• 80% of final strength acheived immediately
• Full strength achieved in 24 hours

• Fast drying with long open time
• Excellent green strength and high heat resistance
• Over 105°C temperature resistant
• No ODS (Ozone Depleting Substances)

• This product is designed to be applied to both surfaces to be bonded together. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 16°C - 27°C.
  
  
• Use with adequate ventilation. Shake the canister well before use. Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
  
  
• Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates.
  
  
• Spray about 10-20 cm away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.

• Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.
• If the spray tip clogs, unscrew the spray tip from the gun and clean with adhesive cleaner such as TensorGrip® C101 citrus cleaner. Do not use a pin on the spray tip orifice.
  
  

• NOT SUITABLE FOR: Polystyrene, some Plastics, Plasticised Vinyl and Polypropylene.