Tensorgrip L20 High Performance Veneer Spray Adhesive

Product Information

Tensorgrip L20 is a fast-drying contact adhesive with good heat resistance. It is suitable for bonding a variety of materials to timber, metal and some hard plastics. Immediate permanent bonds can be achieved by double-sided applications on most substrates.

Tensorgrip L20 is a veneer specialist. It is resistant to solvent-based lacquers, ensuring premium results even on thin veneers.

• Fast Tack
• Low Odour
• Low VOC
• High Green Strength

• High Heat Resistance
• Lacquer Resistant
• Toluene Free

• This product is designed to be applied to both bonding surfaces.
• Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc.
• For best results, the temperature of the adhesive and the surfaces being bonded should be between 16ºC - 27ºC. Use with adequate ventilation.
• When possible we recommend shaking the canister or aerosol well before using.
• Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
• Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates.

• Spray about 10-20 cm away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive.
• Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
• Adhere surfaces and press together with adequate pressure. If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or TensorGrip SC101 citrus cleaner. Do not use a pin on the spray tip orifice