Tensorgrip FS900 Vinyl Bonding Contact Adhesive 22L

Product Information

TensorGrip® FS900 is a fully plasticiser resistant contact adhesive. TensorGrip® FS900 is designed to bond vinyl products such as skirting, wall vinyl and coving. TensorGrip® FS900 is tack ready fast so installation can begin within minutes of the adhesive application.

• Plasticiser Resistant
• High Tack

• High Temperature Resistance
• Water Resistant

• Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc.
  
  
• For best results, the temperature of the adhesive and the surfaces being bonded should be between 16°C - 27°C.
  
  
• Use with adequate ventilation.
  
  
• Shake the canister well before use.
  
  
• Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process.
  
  
• Unlock the trigger on the spray gun to start spraying.
  
  
• Spray about 10 cm away from the surface at a 90 degree angle to the surface.
  
  
• apply a uniform, even coat of adhesive overlapping each pass by 50%

• If necessary, spray another coat of adhesive in areas that appear to need more adhesive.
  
  
• Apply to both surfaces to be bonded, one surface vertically and the other horizontally.
  
  
• This product has a short open time of 12-15 minutes so you may find it necesary to complete your job in sections to ensure the adhesive does not dry before you have completed the bond.
  
  
• Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
  
  
• Adhere surfaces and press together with adequate pressure. A roller is reccomended for even pressure.
  
  
• If the spray tip clogs, unscrew the spray tip from the gun and clean with suited cleaner such as TensorGrip® S105 acetone based adhesive cleaner and remover. Do not use a pin on the spray tip orifice.