Tensorgrip X40 Fast Dry High Grab Spray Adhesive

Product Information

Tensor Grip® X40 is developed in conjunction with the acoustic industry for all acoustic panel bonding applications. Tensor Grip X40 is a fast drying contact adhesive, suitable for all types of acoustic panel installation and applications including in-house and on-site bonding processes.

• Non-Flammable Adhesive
• Excellent High Coverage of up to 230m2 per 22ltr canister
• 80% of Final Strength achieved immediately upon bonding
• Can be tinted for visability of application coverage
• Full strength achieved in 24 hours, high strength long-term bond
• Fast drying 3-4 mins with excellent initial green strength bond
• System with adjustable spray patterns

• High tack – adheres aggressively to most surfaces
• Long open time 60 mins
• High (85°C) temperature heat resistant
• Low Odour – suitable for Building Sites
• Low Atomisation limiting overspray
• Portable Airless self sufficient Aerosol Canister Spray

• Prepare panel and substrate for TensorGrip® X40 adhesive application. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. Apply TensorGrip® X40 adhesive to both the panel and substrate surfaces in an even manner with 80-100% surface coverage. Spray the pattern with a 50% overlap on passes of spray pattern holding the spray gun within 150mm of the surface being sprayed Using a spray-release-spray method to avoid excessive build up of overlapped adhesive patterns. Cutting in can be done by adjusting the spray gun to a smaller fan width spray pattern to allow for intricate spraying Porous surfaces may need a second coat, if needed, allow for first coat to tack-off before applying the second coat.
  
  
• Allow enough time for the glue line to tack-off (3-5 Minutes or until dry but tacky to the touch without any transfer of wet adhesive to fingers) before placing panels and creating the bond. Apply the panel to create the bond within the open time of the Tensor Grip X40 adhesive (within 60 minutes). If you have exceeded the open time, spray a fresh glue line and adhere within the open time. Full Surface pressure must be applied to bonded panel using a laminate type roller within 10 minutes of the panel being applied to facilitate full adhesive transfer and a strong bond. Initial bond is strong enough to allow for cutting or trimming immediately if needed the bonded panel should be smooth and free of air bubbles, wrinkles, gaps and or blemishes.

• Maximum bond strength is achieved with coverage of 100% and recommednded coat weight of 20 dry grams per M2.
  
  
• NOTE: For applications above head height a perimeter bead of construction adhesive, such as INSTA_GRIP X40, must be used in conjunction with this product.
  
  
• Clean any surface as necessary with the Tensor Citrus Based C101 bio-degradable adhesive cleaner and remove